NdFeB Machining Risk Review Buyer Decision Guide Quick Answer: Can You Cut a Finished Neodymium Magnet? In most cases, you should not cut a finished neodymium magnet with ordinary workshop tools. A finished NdFeB magnet is hard, brittle, coated, and

Quick Answer Magnet strength is not measured with one universal number. The correct method depends on what you need to know. A gauss meter measures magnetic flux density at a defined location. A pull force test measures the force required

To find the north and south pole of a magnet, place a compass near one end or one face of the magnet. If the compass needle’s N-marked end points toward that surface, the tested surface is the magnet’s south pole.

Demagnetization is the process of reducing or removing unwanted residual magnetism from a material, workpiece, tool, or component. In manufacturing, the demagnetization process is important because residual magnetism can attract metal chips, affect machining quality, interfere with welding, disturb coating

Magnetic field lines point from the north pole to the south pole outside a magnet. Inside the magnet, they return from the south pole to the north pole. This creates a closed loop. The easiest way to remember it is:

Recentemente, molti venditori Amazon si sono imbattuti in dubbi durante il processo di verifica dei “prodotti magnetici”. Amazon richiede spesso un rapporto di prova magnetica conforme agli standard IATA e, in alcune note di verifica, specifica di misurare l’intensità del campo magnetico (in gauss)